![CAD Forum - tips, tricks, discussion and utilities for AutoCAD, Inventor, Revit and other Autodesk products [www.cadforum.cz]](/common/arkance_186.png "CAD Forum - tips, tricks, discussion and utilities for AutoCAD, Inventor, Revit and other Autodesk products [www.cadforum.cz]")
CAD FORUM - TIPS & TRICKS | UTILITIES | DISCUSSION | BLOCKS | SUPPORT | HELP & ADVICE
Over 1.098.000 registered users (EN+CZ).
AutoCAD tips, Inventor tips, Revit tips.
Try the new precise Engineering calculator and the updated Barcode generator.
New AutoCAD 2026 commands and variables.
Discussion forum
?CAD discussions, advices, exchange of experience
CAD discussion forum - ask any CAD-related questions here, share your CAD knowledge on AutoCAD, Inventor, Revit and other Autodesk software with your peers from all over the world. To start a new topic, choose an appropriate forum.
Please abide by the rules of this forum.
This is a peer-to-peer forum. The forum doesn't replace the official direct technical support provided by ARKANCE for its customers.
How to post questions: register or login, go to the specific forum and click the NEW TOPIC button.
|
Throwback Thursday - Vintage Computer Hardware
Post Reply 
|
| Author | |
BetweenTheLines 
RSS robots 
Joined: 20.Nov.2009 Status: Offline Points: 751 |
 Topic: Throwback Thursday - Vintage Computer HardwarePosted: 17.Jul.2014 at 09:35 |
|
It is always amazing to stumble across computers from the distant past. I have two old vintage computers that I found while was cleaning out of my storage. They both actually boot up and run. The pair are an Apple Macintosh SE with 1Mb RAM and 2- 800k drives from 1987 and a Radio Shack TRS-80 model III from 1983. An original single button Apple Mouse and the old Apple logo sticker. The Radio Shack seal from 1983 It is...
Go to the original post... |
|
|
Between the Lines - Autodesk blog by Shaan Hurley
|
|
 |
|
Topic Options|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
This page was generated in 0,086 seconds.
CADforum
Tips and tricks, support, utilities, help, discussions on AutoCAD, LT, Inventor, Revit, Map, Civil 3D, 3ds Max, Fusion, Forma, Vault, PowerMill and other Autodesk software (community support by ARKANCE). See About CADforum.
Copyright © 2025 | Advertise with us | Online privacy
