Discussion forum

CAD discussion

CAD discussion forum - ask any CAD-related questions here, share your CAD knowledge on AutoCAD, Inventor, Revit and other Autodesk software with your peers from all over the world. To start a new topic, choose an appropriate forum.

Please abide by the rules of this forum.

How to post questions: register or login, go to the specific forum and click the NEW TOPIC button.

Forum Home > EN > AutoCAD

Automatic design based on variables

Post Reply

Page <1 23

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
John Connor Members Profile Find Members Posts Senior Member Joined: 01.Feb.2011 Location: United States Using: AutoCAD 2018 Status: Offline Points: 7175	Posted: 02.Aug.2016 at 13:18
	Kent Cooper has brought up some very valid points. Can we get some response?
	"Humans have a strength that cannot be measured. This is John Connor. If you are reading this, you are the resistance." <<AutoCAD 2015>>

rebellio Members Profile Find Members Posts Senior Member Joined: 04.Mar.2009 Location: Netherlands Using: Autocad 2018 Status: Offline Points: 125	Posted: 11.Aug.2016 at 17:19
	Hi Alex, Found some time to write something for you. Please use the standard drawing that you posted (or the Panel_Inch attached), the lisp is based on that drawing. The Lisp i wrote will "stretch" the lenght and width. If Gap is required open the lisp (notepad) and check this rule "If Gap required set Lgap 0.00 to 0.05 or Up" Load the lisp with Appload and type STRPLA on the command bar to Run. Hope that this will help you. Regards uploads/39979/panel_INCH.dwg uploads/39979/Stretchplate.LSP ps i am used to the metric system and decimal settings.

Related CAD tips:

Post Reply	Page <1 23
Tweet

Forum Jump

Forum Permissions View Drop Down

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

This page was generated in 0,465 seconds.

CZ \| EN \| DE
Login or
registration
	Visitors: 6940

	CAD Forum - tips, tricks, utilities, discussion for AutoCAD, LT, Inventor, Revit, Map, Civil 3D, 3ds Max, Fusion 360 and other Autodesk software (support by Arkance Systems)	Arkance Systems CZ (CAD Studio) - Autodesk Platinum Partner & Training Center & Services Partner	CONTACT: webmaster.cz@arkance-systems.com tel. +420 910 970 111
	Copyright ©2024 \| Advertise with us \| Online privacy