Discussion forum

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   i created a new ucs along the horizontal line right in the picture.
the usc seems correct but the coursor has an different angle.
drawing lines with orthomode results the same different.
the same is shown by switching to WCS
does anybody know witch variable set the different angle to zero?

thanks for helping
Peter

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
CH4 Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 26.Feb.2017 Location: Austria Using: Autocad 2011 Status: Offline Points: 2	Topic: autocad r11, ucs and cursor different angles Posted: 27.Feb.2017 at 00:18
	i created a new ucs along the horizontal line right in the picture. the usc seems correct but the coursor has an different angle. drawing lines with orthomode results the same different. the same is shown by switching to WCS does anybody know witch variable set the different angle to zero? thanks for helping Peter

vicky123@ Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 27.Feb.2017 Location: Pakistan Using: developer2016 Status: Offline Points: 1	Posted: 27.Feb.2017 at 08:31
	Wao Nice
	waqas

ktahameed Members Profile Send Private Message Find Members Posts Add to Buddy List Groupie Joined: 05.Feb.2015 Location: United Arab Emirates Using: AUTOCAD16 Status: Offline Points: 56	Posted: 27.Feb.2017 at 10:27
	use SNAPANG command
	ABUASHIKA

shoebgadakari Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 02.Feb.2017 Location: United Arab Emirates Using: Autocad 2016 Status: Offline Points: 1	Posted: 01.Mar.2017 at 07:37
	Use UCS command and enter V.

Discussion forum

?CAD discussions, advices, exchange of experience

autocad r11, ucs and cursor different angles

?
CAD discussions, advices, exchange of experience