CAD Forum - tips, tricks, discussion and utilities for AutoCAD, Inventor, Revit and other Autodesk products [www.cadforum.cz] ARKANCE | CONTACT - CZ | SK | EN | DE
Over 1.096.000 registered users (EN+CZ). AutoCAD tips, Inventor tips, Revit tips. Try the new precise Engineering calculator and the updated Barcode generator. New AutoCAD 2026 commands and variables.
RSS channel - CAD tips RSS tips
RSS discussions

Discussion Discussion forum

?
CAD discussions, advices, exchange of experience

CAD Forum - Homepage CAD discussion forum - ask any CAD-related questions here, share your CAD knowledge on AutoCAD, Inventor, Revit and other Autodesk software with your peers from all over the world. To start a new topic, choose an appropriate forum.

Please abide by the rules of this forum.
This is a peer-to-peer forum. The forum doesn't replace the official direct technical support provided by ARKANCE for its customers.
How to post questions: register or login, go to the specific forum and click the NEW TOPIC button.
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Topic ClosedCursor or crosshair orientation 2000 LT

 Post Reply Post Reply
Author
berol View Drop Down
Newbie
Newbie


Joined: 02.Nov.2008
Status: Offline
Points: 2
Direct Link To This Post Topic: Cursor or crosshair orientation 2000 LT
    Posted: 02.Nov.2008 at 21:35
Newbee, using 2000 LT, need to change the cursor orientation to 29 degrees and then back to zero.  Could someone help with command line input. Thanks! Big%20smile
DB
Back to Top
Ron C View Drop Down
Groupie
Groupie


Joined: 05.Sep.2008
Location: United States
Using: AutoCAD2010
Status: Offline
Points: 36
Direct Link To This Post Posted: 05.Nov.2008 at 18:33

The command you are looking for is Snapang.

RDC
Back to Top
berol View Drop Down
Newbie
Newbie


Joined: 02.Nov.2008
Status: Offline
Points: 2
Direct Link To This Post Posted: 08.Nov.2008 at 21:37
Smile Thanks Ron, you were the only one to reply, guess being a newbie you understood. Thanks again, Berol
DB
Back to Top
tariq View Drop Down
Groupie
Groupie


Joined: 31.Oct.2007
Location: Oman
Using: 2018
Status: Offline
Points: 67
Direct Link To This Post Posted: 10.Nov.2008 at 07:25

Hi

Use Snap command
 
SN  Enter R  Double Enter Required Angle Enter F9
 
When u back to 0
 
SN Enter R Double Enter angle 0 enter F9
 
You r back to 0 angel
Tariq Mehmood
Back to Top

Related CAD tips:


 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down



This page was generated in 0,162 seconds.