CAD Forum - tips, tricks, discussion and utilities for AutoCAD, Inventor, Revit and other Autodesk products [www.cadforum.cz] ARKANCE | CONTACT - CZ | SK | EN | DE
Over 1.096.000 registered users (EN+CZ). AutoCAD tips, Inventor tips, Revit tips. Try the new precise Engineering calculator and the updated Barcode generator. New AutoCAD 2026 commands and variables.
RSS channel - CAD tips RSS tips
RSS discussions

Discussion Discussion forum

?
CAD discussions, advices, exchange of experience

CAD Forum - Homepage CAD discussion forum - ask any CAD-related questions here, share your CAD knowledge on AutoCAD, Inventor, Revit and other Autodesk software with your peers from all over the world. To start a new topic, choose an appropriate forum.

Please abide by the rules of this forum.
This is a peer-to-peer forum. The forum doesn't replace the official direct technical support provided by ARKANCE for its customers.
How to post questions: register or login, go to the specific forum and click the NEW TOPIC button.
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Topic ClosedWheel Panning Issues

 Post Reply Post Reply
Author
brogers View Drop Down
Newbie
Newbie


Joined: 24.Nov.2008
Location: United States
Status: Offline
Points: 6
Direct Link To This Post Topic: Wheel Panning Issues
    Posted: 24.Nov.2008 at 18:11

OK.....Just started a new job using LT.  Going through setting up my prefences and hop in a drawing and start rolling.  I noticed the center wheel of my mouse will zoom in and out but it will not pan.  I am using a Dell Bluetooth mouse and tried reseting the buttons in the control panel and the prefences in LT.  Even tried the mbuttonpan command with no luck.  Anybody else have any ideas how I can get this to work correctly......

Many Thanks,
 
Back to Top
rossassociates View Drop Down
Groupie
Groupie


Joined: 20.Oct.2008
Location: United Kingdom
Status: Offline
Points: 79
Direct Link To This Post Posted: 26.Nov.2008 at 16:41
I guess you've got a tilt wheel mouse? or are you asking about another type of mouse?  I had to enable the tilt option in the Mouse driver, it works everywhere, IE/FF AutoCAD (2005) etc.. :)

ETA : Mine is a Logitech btw and I had to download a driver for it to tilt.


Edited by rossassociates - 26.Nov.2008 at 16:55
Back to Top
Kajito View Drop Down
Senior Member
Senior Member


Joined: 29.Oct.2008
Location: Ireland
Status: Offline
Points: 130
Direct Link To This Post Posted: 27.Nov.2008 at 12:14
I came across this issue.
It all depends what type of mouse you have. If the mouse is programmable, you need to change the wheel as "middle button" for AutoCAD.
Some mice might have some kind of "cheap software" with it (this software might be installed with widows update), so u will need to uninstall the software.
Back to Top

Related CAD tips:


 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down



This page was generated in 0,172 seconds.