CAD Forum - tips, tricks, discussion and utilities for AutoCAD, Inventor, Revit and other Autodesk products [www.cadforum.cz] ARKANCE | CONTACT - CZ | SK | EN | DE
Over 1.094.000 registered users (EN+CZ). AutoCAD tips, Inventor tips, Revit tips. Try the new precise Engineering calculator. New AutoCAD 2026 commands and variables.
RSS channel - CAD tips RSS tips
RSS discussions

Discussion Discussion forum

?
CAD discussions, advices, exchange of experience

CAD Forum - Homepage CAD discussion forum - ask any CAD-related questions here, share your CAD knowledge on AutoCAD, Inventor, Revit and other Autodesk software with your peers from all over the world. To start a new topic, choose an appropriate forum.

Please abide by the rules of this forum.
This is a peer-to-peer forum. The forum doesn't replace the official direct technical support provided by ARKANCE for its customers.
How to post questions: register or login, go to the specific forum and click the NEW TOPIC button.
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Topic ClosedHow to derived sketch from .Jpg files in Inventor

 Post Reply Post Reply
Author
arfstybd View Drop Down
Newbie
Newbie


Joined: 20.Jan.2010
Location: Indonesia
Using: Inventor2010
Status: Offline
Points: 9
Direct Link To This Post Topic: How to derived sketch from .Jpg files in Inventor
    Posted: 28.Jan.2011 at 11:09
Does anyone knows how to derive sketches from .jpg files?, lets say I have an image from magazine then I scan it so I have a .jpg then I want to have outline sketches from some part of the image in inventor.

thankyou Guys.Smile
You can see it before You create it :)
Back to Top
tattokits View Drop Down
Newbie
Newbie


Joined: 01.Feb.2011
Location: United States
Using: Revit2009
Status: Offline
Points: 1
Direct Link To This Post Posted: 01.Feb.2011 at 12:03
Nice and good point.

Back to Top
tulip3D View Drop Down
Senior Member
Senior Member


Joined: 23.Jul.2009
Location: United States
Using: AutoCAD2011, Inventor2011
Status: Offline
Points: 427
Direct Link To This Post Posted: 01.Feb.2011 at 16:54
Yeah! You zoom in and trace over them...I think somebody might make an add-on that converts jpg to lines, but it aint very accurate.
Back to Top
arfstybd View Drop Down
Newbie
Newbie


Joined: 20.Jan.2010
Location: Indonesia
Using: Inventor2010
Status: Offline
Points: 9
Direct Link To This Post Posted: 02.Feb.2011 at 03:22
ok, thankyou and I'll try it.
You can see it before You create it :)
Back to Top
arfstybd View Drop Down
Newbie
Newbie


Joined: 20.Jan.2010
Location: Indonesia
Using: Inventor2010
Status: Offline
Points: 9
Direct Link To This Post Posted: 02.Feb.2011 at 03:36
thankyou
You can see it before You create it :)
Back to Top

Related CAD tips:


 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down



This page was generated in 0,117 seconds.