CAD Forum - tips, tricks, discussion and utilities for AutoCAD, Inventor, Revit and other Autodesk products [www.cadforum.cz] ARKANCE | CONTACT - CZ | SK | EN | DE
Over 1.096.000 registered users (EN+CZ). AutoCAD tips, Inventor tips, Revit tips. Try the new precise Engineering calculator and the updated Barcode generator. New AutoCAD 2026 commands and variables.
RSS channel - CAD tips RSS tips
RSS discussions

Discussion Discussion forum

?
CAD discussions, advices, exchange of experience

CAD Forum - Homepage CAD discussion forum - ask any CAD-related questions here, share your CAD knowledge on AutoCAD, Inventor, Revit and other Autodesk software with your peers from all over the world. To start a new topic, choose an appropriate forum.

Please abide by the rules of this forum.
This is a peer-to-peer forum. The forum doesn't replace the official direct technical support provided by ARKANCE for its customers.
How to post questions: register or login, go to the specific forum and click the NEW TOPIC button.
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Topic ClosedD sized Layout

 Post Reply Post Reply
Author
CADduder76 View Drop Down
Newbie
Newbie


Joined: 09.May.2011
Location: United States
Using: Auticad 2011, Autocad 2012, Inventor 2011
Status: Offline
Points: 4
Direct Link To This Post Topic: D sized Layout
    Posted: 11.May.2011 at 12:47
OK. Here is another newbie question that has me frustrated. I was getting my CAD project for school ready to plot. I Set the page up for ANSI D and picked the proper plotter. The title block was the correct size and was entering multiline text for my name, class, date etc....When I previewed it before I went to print, all the text I had put into the title block was vertical instead of horizontal like it should be. ???Confused??
Back to Top
John Connor View Drop Down
Senior Member
Senior Member


Joined: 01.Feb.2011
Location: United States
Using: AutoCAD 2018
Status: Offline
Points: 7175
Direct Link To This Post Posted: 11.May.2011 at 17:06
Did you check your text style settings?
"Humans have a strength that cannot be measured. This is John Connor. If you are reading this, you are the resistance."

<<AutoCAD 2015>>

Back to Top
CADduder76 View Drop Down
Newbie
Newbie


Joined: 09.May.2011
Location: United States
Using: Auticad 2011, Autocad 2012, Inventor 2011
Status: Offline
Points: 4
Direct Link To This Post Posted: 11.May.2011 at 17:39
Everything looked alright...I will check again.
Back to Top

Related CAD tips:


 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down



This page was generated in 0,070 seconds.