Recently I have started using CAD 2012. Since last 3 year we were working on LT 2007. Now when i am working on same files on my CAD 2012, I am facing a strange problem. Please note there are 02 other colleugue of mine, who are using CAD 2012, but they never came acroos such problems.

 

For ex., I have a floor plan, where to show 03 diff types material, I have used Ansi 132/ ANSI 137 & AR- Conc. Till the time we were working on LT, it was fine, but the moment I edited the hatch in my drg, it was converted into Solid fill on its own. I checked, but it was not the densing og hatch, but all the patterns were converted into solid fill. Since then i have re corrected hatches 5-6 times, but this problem always persists. Also this is happening with new files even.

 

I had contacted the CAD vendor, he had installed service pack & rechecked the location of dll files, but still I am facing this problem.

 

Would like to know if any one has faced the same issues or if any of you has a solution for this?

 

Please help

 

Thanks a lot for the help.

 

May I request you to post your ID, to send you the CAD files.

 

Thanks