CAD Forum - tips, tricks, discussion and utilities for AutoCAD, Inventor, Revit and other Autodesk products [www.cadforum.cz] ARKANCE | CONTACT - CZ | SK | EN | DE
Over 1.094.000 registered users (EN+CZ). AutoCAD tips, Inventor tips, Revit tips. Try the new precise Engineering calculator. New AutoCAD 2026 commands and variables.
RSS channel - CAD tips RSS tips
RSS discussions

Discussion Discussion forum

?
CAD discussions, advices, exchange of experience

CAD Forum - Homepage CAD discussion forum - ask any CAD-related questions here, share your CAD knowledge on AutoCAD, Inventor, Revit and other Autodesk software with your peers from all over the world. To start a new topic, choose an appropriate forum.

Please abide by the rules of this forum.
This is a peer-to-peer forum. The forum doesn't replace the official direct technical support provided by ARKANCE for its customers.
How to post questions: register or login, go to the specific forum and click the NEW TOPIC button.
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Topic ClosedAdaptive Parts

 Post Reply Post Reply
Author
BJ1702 View Drop Down
Newbie
Newbie


Joined: 08.Apr.2011
Location: Australia
Using: AutoCAD2009
Status: Offline
Points: 2
Direct Link To This Post Topic: Adaptive Parts
    Posted: 27.Sep.2012 at 05:51
After a bit of help.
Using Inventor 2012
I have an adaptive part with holes 100mm in from each end as well as 3 holes evenly spaced along the length of the part. They work fine with the adaptive aspect as one spacing is equal to the next. However what I want to know is if the part grows to a length that the hole centres are more than say 300mm apart is Inventor smart enough to add an additional hole? If so how do I go about defining this?
Any help would be great.
Thanks
Back to Top

Related CAD tips:


 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down



This page was generated in 0,254 seconds.