Discussion forum

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   I have loaded a copy of DraftSight. When I try to select multipal enties with the pick box it un-selects the previous one when I select the new one. I know this must be a setting that needs to be changed, but can not find it.

Any advice would be appreciated.

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
itzamaija02 Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 21.Apr.2013 Location: United States Using: DraftSight Status: Offline Points: 2	Topic: DraftSight question Posted: 22.Apr.2013 at 00:21
	I have loaded a copy of DraftSight. When I try to select multipal enties with the pick box it un-selects the previous one when I select the new one. I know this must be a setting that needs to be changed, but can not find it. Any advice would be appreciated.

John Connor Members Profile Send Private Message Find Members Posts Add to Buddy List Senior Member Joined: 01.Feb.2011 Location: United States Using: AutoCAD 2018 Status: Offline Points: 7175	Posted: 22.Apr.2013 at 11:55
	I'd try either PICKFIRST or PICKADD or whatever the AutoCAD equivalent command is in DraftSight. I think these are the equivalent commands in DraftSight: ENBLENTSELPRESEL SETENTSELADD Set each to a value of "1". Edited by John Connor - 22.Apr.2013 at 13:21
	"Humans have a strength that cannot be measured. This is John Connor. If you are reading this, you are the resistance." <<AutoCAD 2015>>

Discussion forum

?CAD discussions, advices, exchange of experience

DraftSight question

?
CAD discussions, advices, exchange of experience