CAD Forum - Database of tips, tricks and utilities for AutoCAD, Inventor and other Autodesk products [www.cadforum.cz]
CZ | EN | DE
Login or
registration
  Visitors: 6177
RSS channel - CAD tips RSS tips
RSS discussions

Discussion Discussion forum

 

HelpCAD discussion

 
CAD Forum - Homepage CAD discussion forum - ask any CAD-related questions here, share your CAD knowledge on AutoCAD, Inventor, Revit and other Autodesk software with your peers from all over the world. To start a new topic, choose an appropriate forum.

Please abide by the rules of this forum.

How to post questions: register or login, go to the specific forum and click the NEW TOPIC button.
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Topic ClosedConnect line to a circle

 Post Reply Post Reply
Author
HarunT View Drop Down
Newbie
Newbie


Joined: 02.Mar.2017
Location: United Kingdom
Using: Autocad 2014
Status: Offline
Points: 2
Direct Link To This Post Topic: Connect line to a circle
    Posted: 02.Mar.2017 at 16:53
uploads/710612/images_1.pdf

Hi there, 
how can i connect this line to any point on the circle? this is what it looks like when i zoom in. 
 hope you can help. 
HT
Back to Top
Vladimir Michl View Drop Down
Moderator Group
Moderator Group

Arkance Systems CZ

Joined: 26.Jul.2007
Location: Czech Republic
Using: Autodesk software
Status: Offline
Points: 2015
Direct Link To This Post Posted: 02.Mar.2017 at 16:59
If you use OSNAP, your geometry should be precise - despite it may be displayed disconnected in extreme zoom levels.
 
Make sure your geometry is not too far from the world origin (0,0,0).
Vladimir Michl (moderator)
Arkance Systems - arkance-systems.cz - Autodesk reseller
Back to Top
John Connor View Drop Down
Senior Member
Senior Member


Joined: 01.Feb.2011
Location: United States
Using: AutoCAD 2018
Status: Offline
Points: 7175
Direct Link To This Post Posted: 02.Mar.2017 at 17:08
If the line is not connected to a quadrant or tangent to the circle then to connect it to any point on the circle try drawing a temporary line that intersects the circle then use the INTERSECTION osnap to make the connection.
"Humans have a strength that cannot be measured. This is John Connor. If you are reading this, you are the resistance."

<<AutoCAD 2015>>

Back to Top
Kent Cooper View Drop Down
Senior Member
Senior Member


Joined: 12.Mar.2013
Location: United States
Using: AutoCAD2020, 2023
Status: Offline
Points: 616
Direct Link To This Post Posted: 02.Mar.2017 at 18:58
If you used some Osnap mode to put it on the Circle, or Trim or Extend, and if this is Zoomed significantly in since then, it's just a matter of display resolution.  REGEN and it will probably meet visually [it really does meet geometrically already].  It's a function of the way curves are segmented in display only.  To at least lessen the effect, go into VIEWRES and give it a higher Circle Zoom Percentage.
Back to Top

Related CAD tips:


 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down



This page was generated in 0,396 seconds.