|
Byl uvolněn "Update 6 pro Inventor 2013 SP2". Tento update obsahuje všechny hotfixy uvedené po Service Packu 2 k Inventoru 2013. Ke stažení na: http://knowledge.autodesk.com/support/inventor-products/downloads/caas/downloads/content/update-6-for-inventor-2013-service-pack-2.html" rel="nofollow - http://knowledge.autodesk.com/support/inventor-products/downloads/caas/downloads/content/update-6-for-inventor-2013-service-pack-2.html Nové opravy uvedené v Update 6:
-
1471-513: VBA DrawingCurves(ComponentOccurrence)
method fails on specific drawing view
-
1518-199: The setting of template for assembly in make
component configuration is not retained
-
1518-155: Select a point of sketch is disabled after
edit the sketch
-
1517-471: Moment of Inertia is calculated to negative
value
-
1518-347: Unable to add features to data after opening
and closing multiple times in the same session
-
1518-402: Updating drawing corrupts section view
-
1420-905: Incorrect Master Mass is calculated when
generating Shrinkwrap
-
1517-349: Unexpected exit updating second derived part
after deleting the geometry in sketch block within the base part
-
1507-142: Unexpected exit in
XLayerExternalResolver::ResolveFile() when running VBA
-
1518-794: Unexpected exit when working with part in
non-English version after installing Update3
-
1480-054: Unexpected exit after IKM Import and
dragging part
-------------
Vladimír Michl (moderátor)
ARKANCE CZ - https://arkance.world - arkance.world
(podpora viz emea.support.arkance.world)
|