How to move LINE to 3D point, or point in block? XY are same,Line is on Z=0 and point is above.

Use a filter?

filter to select and?

To place the point relative to an X/Y coordinate.

Maybe I don't understand what you're asking, but it sounds to me as though you should be able to select the Line, pick on any of its grips, hit Enter/space to get into the Move command, and then either object-snap to the 3D location if you can, or else use the .XY option and snap to the appropriate point on the Line, then give it a Z value or snap to anything in the Block that is at the desired elevation -- that should allow you to snap to some location where it's not going to snap to the Line again.

I have a lot of lines on elevation zero (Z=0) and I need  to make a 3D drawing from it. And all lines have a points on edge. I can easy set points to 3D positions, but lines are problems. i can do that manually, line to 3D point but its to slow and i think maybe someone on this forum have a AutoCAD Lisp for it.