Display full version of the post: Block problem
So I have created multiple blocks in my drawing and saved them. When I insert them into my drawing it is inserting the block, although it is in multiple lines not as one entity. Any suggestions!?
John Connor
11.06.2011, 22:52
Did you save each block individually or were all the "blocks" (as you call them) saved as one?
They were saved individually in another drawing and inserted into my new drawing.
Imad Habash
12.06.2011, 07:35
well... when the insert dialogue appear , check out the EXPLODE small box down there..
i hope it's help.
Regards,