knight2255
03.09.2009, 00:22
I am a total autocad newb. Just learning the basics. Couple
things I can't figure out. I'm trying to replicate the drawing on the
top. I'm working on the bottom one. How do I get the 1/4" dimension
numbering on either side of the 7" to line up like the top? What is the
font used on the top one, I can't seem to find it in autocad. Lastly,
what is an easy way to make those angles in the insets? The only method
I could come up was to make to make the 1/2" deep inset at 90 degree
angles and then come back and draw a 1/4" box on either end. Then I'd
draw the diagonal line in the 1/4" box to make the angle and then erase
the lines not needed. Seems kind of tedious, just wondering if there is
an easier way. Thanks.
things I can't figure out. I'm trying to replicate the drawing on the
top. I'm working on the bottom one. How do I get the 1/4" dimension
numbering on either side of the 7" to line up like the top? What is the
font used on the top one, I can't seem to find it in autocad. Lastly,
what is an easy way to make those angles in the insets? The only method
I could come up was to make to make the 1/2" deep inset at 90 degree
angles and then come back and draw a 1/4" box on either end. Then I'd
draw the diagonal line in the 1/4" box to make the angle and then erase
the lines not needed. Seems kind of tedious, just wondering if there is
an easier way. Thanks.