Hello. I'm a amateur user of AutoCAD and today when I started drawing I realized that when I selected an endpoint it didn't show the drawing's units or angle. And I can not see or toogle between them using the TAB-key. This is really getting on my nervs so if someone know any way to make the default config the current or what I could've changed by mistake so I may correct it I will be most thankful.
Cheers // Robert

[QUOTE=Prophet]Hello. I'm a amateur user of AutoCAD and today when I started drawing I realized that when I selected an endpoint it didn't show the drawing's units or angle. And I can not see or toogle between them using the TAB-key. This is really getting on my nervs so if someone know any way to make the default config the current or what I could've changed by mistake so I may correct it I will be most thankful.
Cheers // Robert[/QUOTE]May be some ways to avoid it.Go to Tools-->options-->Profiles--->unnamed profile.Or check the AutoCAD Workspace!.

Depending on how old your version of AutoCAD is (I have 2009.) This is what worked for me.
 
-Right click on Snap
-Click 'Dynamic Input' to change your crosshair reference and data, or change the prompting of information your crosshairs give you.
-Or, click the 'Options' tab at the bottom left corner, and it lists options for your personal preference.
 
~Hope this helps. 

Thanks, all works as usual now. Much appreciation to you two.Thanks, once again. // Robert