Hello am new tho the forum but will get stuck in straigh away.i am looking well trying to make a dynamic tree block that has the following needs.North, South, East, West crown of tree spread.Trunk diamitor.Layer association.The trunk and layers are not the problem but its the N,S,E,W i have tryed a lot a differing polyline options and line options to make a dynamic block work but i keep getting ether.Line leave behind or a bulbus line.The N,S,E,W, can some times be as follows in meters.N3,S1,E9.W4 so if you can imagine when you do a block a input the S, you get a small outage, then the E, you get a bulbus point.the problem is getting the grips right i have tryed four points dynamics.and eight points dynamics. with differing results.all though not a realistic look.Any suggestions would be greatfull.Scott