when i hatch in ground floor any pattern with scale 30 its ok. but when i hatch same pattern in first floor with scale 30 its look too small like solid hatch. how i can resolve this issue.

Did you try changing the scale of the hatch pattern?Are these two separate drawings?

yes both are separate drawings. yes i tried to change the scale. if is in GF 30 then i have to keep in FF 500.. why i cant keep the same scale.. in both dwgs..

It's possible someone used an imperial hatch pattern in a drawing that was set up to use metric units.Open each drawing and type at the command line: MEASUREMENT and compare the resultant values.  They should be the same.

MEASUREMENT=1 uses acadiso.pat  (metric)



MEASUREMENT=0 uses acad.pat   (imperial)



John Connor2015-06-15 16:59:05

thanks. mesurement command solve my problem...