CAD Forum ► EN ► AutoCAD ► I would like to reproduce this PART if in 3D
Display full version of the post: I would like to reproduce this PART if in 3D
I would like to reproduce this part if in 3D I would like to know if someone can help me to reproduce this in 3D I will like to reproduce it with my 3D printer
John Connor
03.03.2019, 13:56
Do you have a similar part that you can take measurements from or that can be scanned so you can construct a digital 3D model?
NO I'M NOT HERE IS A MAY HAVE THE PROBLEM the messure is 40 cm long and 27 cm wide
philippe JOSEPH
04.03.2019, 07:13
The part that we can see on the photo of the quad is not measuring 40 cm x 27 cm
I took the measurements on the radiator that is fixed but I do not have the exact measurements
John Connor
05.03.2019, 12:08
It seems rather useless to me to attempt to reproduce a part in 3D if you don't have exact measurements. You would be asking for trouble. There could be conflicts with other parts and/or the mounting holes might not line up. If either would be the case then you would have to scrap what you made and start over again. Get the part 3D scanned. Don't rely on hand measuring as it would be too inaccurate.
good i will print and adjust to was and measure up to have the right measures