I am using the Plot Style manager to manage lines on a drawing. Everything is good except that when I run these lines into an object, the plotted line will extend beyond the object that it’s supposed to be connected to. I have experimented with the Line End Style but still have the same issue. Any pointers would be appreciated.
btw, I always make the end point to the midpoint of object, and it looks correct before plotting. 
The lines are set with the following parameters in the Plot Style manager:
Enable Dithering = On
Grayscale=Off
Use Assigned Pen # =Auto
Screening =100
Linetype=Use Object Linetype
Adaptive Adjustment=On
Line weight=1.200 mn
Line End Style=Butt
Line Join=Use Object Join Style
Fill Style=Use Object Fill Style
 
 

Try to plot the drawing first to a DWF file and then print the DWF file with Design Review - it may be caused by the driver settings.