I have a keynote block attached to multileaders.  The keynote works fine and you can attach multiple multileaders at both sides.  However, when you rotate the viewport 90 degrees and you try to have multileaders on both sides of the keynote the landing strikes through the block instead of jumping to the other side (like it does normally).  I have used (UCS -> View) in the viewport but the problem still exists.  I have attached a file showing the problem.  Any advice would be helpful.  I am working on office standards and I know I am going to get a lot of complaints if the only solution is to attach a separate multileader to the other side.uploads/265993/keynote_conundrum.dwg