trent13az
06.01.2013, 23:43
need help with this test on 2013 and I haven't used autocad since the early 90's...
1. Which of the following
AutoCAD features allows you to pick up points only along the horizontal and
vertical quadrant lines from a given starting point?
A. LINE
B. Snap
C. Ortho
D. 3D Object Snap
My Answer: B
3. Which of the following
statements about Grid is correct?
A. Grid is only a visual reference; it has no effect on the selection
of points.
B. Grid effects the selection of points.
C. Grid is invisible.
D. Grid and Snap always have the same setting.
My Answer: B
8. When you're inputting
coordinates at the on-screen prompt, which one of the following statements is
correct?
A. Relative coordinates are specified by typing coordinates with no
prefix.
B. Absolute coordinates are specified by typing the @ prefix.
C. Relative coordinates are specified by typing the # prefix.
D. Absolute coordinates are specified by typing the # prefix.
My Answer: A
10. When drawing a horizontal
line that's 15 decimal units long to the right, the correct polar coordinate
display should read
A. 15.0000 < 90,0.0000.
B. 0.0000 < 15,0.0000.
C. 15.0000 < 180,0.0000.
D. 15.0000 < 0,0.0000.
My Answer: C
13. The default paper size and
grid line increments for an acad.dwt drawing template is
A. 8 1/2 inches � 11 inches, and 1.0000 spacing.
B. 12 inches � 9 inches, and 0.5000 spacing.
C. 11 inches � 17 inches, and 1.0000 spacing.
D. 24 inches � 36 inches, and 0.5000 spacing.
My Answer: C
14. After executing the ZOOM
command, the following information appears in the command line:
[All/Center/Dynamic/Extents/Previous/Scale/Window/Object]
If you press <Enter> on your keyboard in response to this prompt,
which of the following ZOOM options will be activated?
A. ScaleB. real time
C. All
D. Extents
My Answer: C
16. Where should you look on
the AutoCAD screen to find the application status bar?
A. On the left edge of screen
B. At the top of the screen
C. At the bottom of the screen
D. On the right edge of the screen
My Answer: D
17. Using Dynamic Input and
decimal units, imagine that you've drawn a jagged line that ends at the
absolute coordinates (5, 8). To draw a line back to the XY origin using
absolute coordinates, you should type _______ at the Specify next point:
prompt.
A. −5, −8
B. 0,0
C. #−5,−8
D. #0,0
My Answer: A
20. You can press the
<F7> key in AutoCAD to turn on the
A. Polar Tracking.
B. Ortho Mode.
C. Grid Display.
D. Snap Mode.
My Answer: B