I have had this issue for a long time and not been able to figure out what causes it.On a variety of drawings I have a number of Paperspace layout tabs.Each layout tab has the drawing number in the title block in paperspace in the bottom right corner.On some tabs, when I print them to PDF, the bottom half of the drawing number is cropped or blanked off, however the rest of the title block lines around and below it print fine.On other tabs it all prints OK.The properties of the text appear to be the same and the size of the text frame appears the same on "good" and "bad" tabs. On the "bad" layouts, the cut-off printing happens if I use "Microsoft print to PDF" or "Scansoft PDF Create!" plotters, but there is no cut off if I use "DWG to PDF" plotter.I assume therefore that it must be a combination of two things:1. something in the different plotter configs that is different between them2. something is different in the good and bad paperspace layouts, that the different plotters are treating differently Hopefully someone can assist please as it would be good to be able to have anyone plot any layout on any loaded PDF plotter! Many thanks!