Display full version of the post: PDMODE
PDMODE doesn't seem to work on my AutoCAD 2013 program. Every time I check it is set to 35, but when dividing a line, the point is always a dot.
heinsite
19.05.2013, 11:09
Points will plot as a dot if you're on the DEFPOINTS layer. Get off of that if that's where you are and you should be fine.Dave.
Kent Cooper
20.05.2013, 14:37
Check your PDSIZE value, too.
heinsite
20.05.2013, 14:48
Regardless of PDSIZE or PDMODE a point will still display as a dot if it's on the DEFPOINTS layer.Dave.