So sheet sets have made my life so much easier that I figured printing through them would be a piece of cake! Well for some reason, when I either "Publish to PDF" or "Publish using page setup overide" to choose my page setup, it always cuts off the right side of the page!!!!! My page set up is correct. When I plot or PDF in the actual drawing (not through the sheet set manager) it prints perfectly fine. The last thing I want is to open up 50 drawings to PDF or Print when the Sheet set manager should do it with no problems!!! Any ideas or advice.
 
Thanks 

Every printer has unique settings, but when I have that problem of getting only half of the image, I go to the Plot Display. In the Printer/plotter box, I push the Properties button. Then in the Plotter Configuration Editor Display, I push the Custom Properties button. Then in the Plotter Properties Display, I push the Page Setup Tab. Then in the Roll Paper Width, I make sure that it is the proper size.  Even though its a PDF, sometimes the paper size makes the difference. I hope these suggestions get you headed in the right path for your solution. Good Luck -KLYPH