Display full version of the post: Read only / write protection

Alan Reed
03.01.2013, 16:07

Due to a computer failure I have had to reinstall Autocad LT2013 on a new computer and I obtained the activation code. However when I open a drawing (installed onto the new computer C:drive) I keep getting 'this file is read only' even after unchecking the relevant box in drawing properties. I have attempted to copy the information into a new file but no luck, 'this file is write protected. Any help to remove this problem would be greatly appreciated. Regards Alan

John Connor
04.01.2013, 11:33

If you are working off a network one possible cause is a timing conflict involving your server.Where are you attempting to save your DWG files to?  What is the full path?John Connor2013-01-04 11:35:22

Alan Reed
04.01.2013, 12:22

Thanks John. I am working from a stand alone system.I have solved one problem by changing the Administrator settings and this then allows me access to the drawing files. But still have a problem with templates. The files are all on my internal hard drive.  Regards Alan

John Connor
04.01.2013, 14:54
What is the problem with your templates?