Aistis88
10.09.2013, 08:05
I create assemblys using "Autodesk subassembly composer ". I import
them and build a corridor from them. If i make corridor from one
assembly with "pave offset target" and other "target to surface" i have
to set those targets in corridor. Problem is - if that corridor have
like for example 10 regions, i have to set same targets for all regions
and its is quite difficult , couse usually i have like 2-3 assemblys
with different construction but the same targets and like 20-30 regions ,
so if my corridor must target pave offset i have to set that SAME
target for the right and for the left side 30x2 = 60 times. Is there any possibility that could remove this misery ?