I have a deed with survey units on but have no idea how to map this out in AutoCAD. The readings are as such:S.47Degrees E for a distance of 177'3"S.29.5degrees E for a distance of 333'N.71.5degrees E for a distance of 358'6"N.20degrees W for a distance of 165'10"S.64degrees W for a distance of 197'....and so on. How would I enter these or convert so that they can be entered?I have seen plenty of posts with degrees and minutes, seconds. I do not have any minutes or seconds as you can see. I need to do a survey lot plan for a permit application and approval. Any help greatly appreciated.

See the following tip:http://www.cadforum.cz/cadforum_en/how-to-enter-angles-in-survey-units-tip10412

You first have to start by invoking the UNITS command where, if you look on the right side of the window, you'll see Angle > Type.  This is where you pick Surveyor's Units from the drop down list.  Then below that you'll see Precision.  I recommend the second one on the drop down list which reads N0d00'00"E.  To accept the changes click on the OK button.