Display full version of the post: ZOOM PROBLEM
Mike Van Eden
23.09.2012, 17:56
uSING ACAD 2013 3D MODEL IN WORLD UCS.
WHEN ZOOMED IN TO FINE DETAIL, THE CROSS HAIRS WILL NOT TRAVERSE OVER THE WHOLE OF THE DRAWING AREA. AS I MOVE THE MOUSE POINTER THE CROSS HAIRS GET TO A POSITION ON THE SCREEN AND SRTAYS THERE EVEN THOUH THE POINTER HAS MOVED. cROSS HAIRS EVEN COMP-LETLEY DISSAPEAR OF THE SCREEN AREA
John Connor
24.09.2012, 11:33
You don't have SNAP enabled do you?
Mike Van Eden
24.09.2012, 22:17
snap is not enabled
good morning evry body. i like to ask you. how to change angle datum to degre. when i introduce angle it' s always in grade
thks!
harison2012-09-25 09:12:47
John Connor
25.09.2012, 12:38
harison:It isn't nice to steal a thread someone started dude.Look in UNITS > Type and check Precision too.
Mike Van Eden
29.09.2012, 07:57
is anyone interested in my problem it may cost me my job
heinsite
29.09.2012, 09:52
First thing I would try would be a REGENALL. Next thing would be to check the drawing limits.
Dave.
Mike Van Eden
30.09.2012, 10:29
thanks for your reply Dave. I tried it and still have the problemon both 2011 and 2013 versions , so i think it may be some setting. this was found on two totally diffent pc's which leads me to beleive it is settings problem
John Connor
30.09.2012, 18:37
Have you tried swapping out the mouse for a different one. Maybe it is malfunctioning.
Mike Van Eden
01.10.2012, 07:00
No but the problem occurrs with other hardware mouse etc on different pc
John Connor
01.10.2012, 11:34
Is the software legal?
Mike Van Eden
01.10.2012, 19:48
yes it is definately legal and registered