CAD Forum discussion (EN) : Survey units...

CAD Forum discussion (EN) : Survey units... https://www.cadforum.cz/forum_en/ Wed, 10 Jun 2026 14:59:54 +0000 Fri, 17 Jul 2015 12:04:33 +0000 http://blogs.law.harvard.edu/tech/rss Web Wiz Forums 12.04 360 https://www.cadforum.cz/forum_en/RSS_post_feed.asp?TID=11272 <![CDATA[CAD Forum discussion (EN)]]> https://www.cadforum.cz/forum_en/forum_images/web_wiz_forums.png https://www.cadforum.cz/forum_en/ <![CDATA[Survey units... : You first have to start by invoking...]]> https://www.cadforum.cz/forum_en/forum_posts.asp?TID=11272&PID=30120&title=survey-units#30120 Author: John Connor
Subject: 11272
Posted: 17.Jul.2015 at 12:04

You first have to start by invoking the UNITS command where, if you look on the right side of the window, you'll see Angle > Type. This is where you pick Surveyor's Units from the drop down list. Then below that you'll see Precision. I recommend the second one on the drop down list which reads N0d00'00"E. To accept the changes click on the OK button.
]]> Fri, 17 Jul 2015 12:04:33 +0000 https://www.cadforum.cz/forum_en/forum_posts.asp?TID=11272&PID=30120&title=survey-units#30120 <![CDATA[Survey units... : See the following tip:http:/...]]> https://www.cadforum.cz/forum_en/forum_posts.asp?TID=11272&PID=30118&title=survey-units#30118 Author: Vladimir Michl
Subject: 11272
Posted: 17.Jul.2015 at 10:05

See the following tip:

http://www.cadforum.cz/cadforum_en/how-to-enter-angles-in-survey-units-tip10412

]]> Fri, 17 Jul 2015 10:05:23 +0000 https://www.cadforum.cz/forum_en/forum_posts.asp?TID=11272&PID=30118&title=survey-units#30118 <![CDATA[Survey units... : I have a deed with survey units...]]> https://www.cadforum.cz/forum_en/forum_posts.asp?TID=11272&PID=30117&title=survey-units#30117 Author: Nhrafan26
Subject: 11272
Posted: 17.Jul.2015 at 08:52

I have a deed with survey units on but have no idea how to map this out in AutoCAD.

The readings are as such:

S.47Degrees E for a distance of 177'3"

S.29.5degrees E for a distance of 333'

N.71.5degrees E for a distance of 358'6"

N.20degrees W for a distance of 165'10"

S.64degrees W for a distance of 197'

....and so on.

How would I enter these or convert so that they can be entered?

I have seen plenty of posts with degrees and minutes, seconds. I do not have any minutes or seconds as you can see.

I need to do a survey lot plan for a permit application and approval.

Any help greatly appreciated.

]]> Fri, 17 Jul 2015 08:52:03 +0000 https://www.cadforum.cz/forum_en/forum_posts.asp?TID=11272&PID=30117&title=survey-units#30117