CAD Forum discussion (EN) : 3D printing https://www.cadforum.cz/forum_en/ Fri, 12 Jun 2026 02:28:32 +0000 Tue, 01 May 2018 11:18:00 +0000 http://blogs.law.harvard.edu/tech/rss Web Wiz Forums 12.04 360 https://www.cadforum.cz/forum_en/RSS_post_feed.asp?TID=12722 <![CDATA[CAD Forum discussion (EN)]]> https://www.cadforum.cz/forum_en/forum_images/web_wiz_forums.png https://www.cadforum.cz/forum_en/ <![CDATA[3D printing : A quarter of an inch thick? Seems...]]> https://www.cadforum.cz/forum_en/forum_posts.asp?TID=12722&PID=35999&title=3d-printing#35999 Author: John Connor
Subject: 12722
Posted: 01.May.2018 at 11:18

A quarter of an inch thick?  Seems rather thick for a bezel.

You don't give the radius for the two upper corners nor do you provide a radius for the filleted edge.

So you created a drawing in AutoCAD and exported it as a .stl file.  Is that correct?
]]> Tue, 01 May 2018 11:18:00 +0000 https://www.cadforum.cz/forum_en/forum_posts.asp?TID=12722&PID=35999&title=3d-printing#35999 <![CDATA[3D printing : Normal 0 ...]]> https://www.cadforum.cz/forum_en/forum_posts.asp?TID=12722&PID=35994&title=3d-printing#35994 Author: Glynndale702
Subject: 12722
Posted: 01.May.2018 at 07:29

I am trying to create a project for 3 D printing this is myfirst time and I having allot trouble doing it can any body help me figure thisout I would really appreciate it what I am trying to do is make a new car radiodash bezel the measurements for it is in picture attached picture 1 I tried tocreated  a stl file so it could be printed soI don’t know if I did this right can anybody take a look at this and tell what’swrong or help me design it better I went to send it to get printed but then itasked me scale it is this the right measurements to get it printed

 

 

Size 1.00 x20.00x13.64mm (0.04 x 0.79 x 0.54 in)

 

 

I would appreciate any help thanks guys

]]> Tue, 01 May 2018 07:29:51 +0000 https://www.cadforum.cz/forum_en/forum_posts.asp?TID=12722&PID=35994&title=3d-printing#35994