CAD Forum discussion (EN) : Lines run past objects https://www.cadforum.cz/forum_en/ Sun, 03 May 2026 06:18:06 +0000 Mon, 17 Aug 2009 22:10:14 +0000 http://blogs.law.harvard.edu/tech/rss Web Wiz Forums 12.04 360 https://www.cadforum.cz/forum_en/RSS_post_feed.asp?TID=2298 <![CDATA[CAD Forum discussion (EN)]]> https://www.cadforum.cz/forum_en/forum_images/web_wiz_forums.png https://www.cadforum.cz/forum_en/ <![CDATA[Lines run past objects : Try to plot the drawing first...]]> https://www.cadforum.cz/forum_en/forum_posts.asp?TID=2298&PID=6438&title=lines-run-past-objects#6438 Author: Vladimir Michl
Subject: 2298
Posted: 17.Aug.2009 at 22:10

Try to plot the drawing first to a DWF file and then print the DWF file with Design Review - it may be caused by the driver settings.]]> Mon, 17 Aug 2009 22:10:14 +0000 https://www.cadforum.cz/forum_en/forum_posts.asp?TID=2298&PID=6438&title=lines-run-past-objects#6438 <![CDATA[Lines run past objects : I am using the Plot Style manager...]]> https://www.cadforum.cz/forum_en/forum_posts.asp?TID=2298&PID=6406&title=lines-run-past-objects#6406 Author: cure4glass
Subject: 2298
Posted: 12.Aug.2009 at 16:46

I am using the Plot Style manager to manage lines on a drawing. Everything is good except that when I run these lines into an object, the plotted line will extend beyond the object that it’s supposed to be connected to. I have experimented with the Line End Style but still have the same issue. Any pointers would be appreciated.

btw, I always make the end point to the midpoint of object, and it looks correct before plotting. 

The lines are set with the following parameters in the Plot Style manager:

Enable Dithering = On

Grayscale=Off

Use Assigned Pen # =Auto

Screening =100

Linetype=Use Object Linetype

Adaptive Adjustment=On

Line weight=1.200 mn

Line End Style=Butt

Line Join=Use Object Join Style

Fill Style=Use Object Fill Style

 

 

]]> Wed, 12 Aug 2009 16:46:27 +0000 https://www.cadforum.cz/forum_en/forum_posts.asp?TID=2298&PID=6406&title=lines-run-past-objects#6406