CAD Forum discussion (EN) : Printing through sheet manager https://www.cadforum.cz/forum_en/ Fri, 04 Sep 2026 22:18:03 +0000 Fri, 11 Dec 2009 15:12:02 +0000 http://blogs.law.harvard.edu/tech/rss Web Wiz Forums 12.04 360 https://www.cadforum.cz/forum_en/RSS_post_feed.asp?TID=2852 <![CDATA[CAD Forum discussion (EN)]]> https://www.cadforum.cz/forum_en/forum_images/web_wiz_forums.png https://www.cadforum.cz/forum_en/ <![CDATA[Printing through sheet manager : Every printer has unique settings,...]]> https://www.cadforum.cz/forum_en/forum_posts.asp?TID=2852&PID=7625&title=printing-through-sheet-manager#7625 Author: KLYPH
Subject: 2852
Posted: 11.Dec.2009 at 15:12

Every printer has unique settings, but when I have that problem of getting only half of the image, I go to the Plot Display. In the Printer/plotter box, I push the Properties button. Then in the Plotter Configuration Editor Display, I push the Custom Properties button. Then in the Plotter Properties Display, I push the Page Setup Tab. Then in the Roll Paper Width, I make sure that it is the proper size.  Even though its a PDF, sometimes the paper size makes the difference. I hope these suggestions get you headed in the right path for your solution. Good Luck -KLYPH

]]> Fri, 11 Dec 2009 15:12:02 +0000 https://www.cadforum.cz/forum_en/forum_posts.asp?TID=2852&PID=7625&title=printing-through-sheet-manager#7625 <![CDATA[Printing through sheet manager : So sheet sets have made my life...]]> https://www.cadforum.cz/forum_en/forum_posts.asp?TID=2852&PID=7621&title=printing-through-sheet-manager#7621 Author: RAM_Z
Subject: 2852
Posted: 10.Dec.2009 at 21:03

So sheet sets have made my life so much easier that I figured printing through them would be a piece of cake! Well for some reason, when I either "Publish to PDF" or "Publish using page setup overide" to choose my page setup, it always cuts off the right side of the page!!!!! My page set up is correct. When I plot or PDF in the actual drawing (not through the sheet set manager) it prints perfectly fine. The last thing I want is to open up 50 drawings to PDF or Print when the Sheet set manager should do it with no problems!!! Any ideas or advice.
 
Thanks 
]]> Thu, 10 Dec 2009 21:03:15 +0000 https://www.cadforum.cz/forum_en/forum_posts.asp?TID=2852&PID=7621&title=printing-through-sheet-manager#7621