https://www.cadforum.cz/forum_en/ Sun, 26 Apr 2026 08:13:35 +0000 Sun, 11 Apr 2010 01:53:54 +0000 http://blogs.law.harvard.edu/tech/rss Web Wiz Forums 12.04 360 https://www.cadforum.cz/forum_en/RSS_post_feed.asp?TID=3602 https://www.cadforum.cz/forum_en/forum_images/web_wiz_forums.png https://www.cadforum.cz/forum_en/ https://www.cadforum.cz/forum_en/forum_posts.asp?TID=3602&PID=9363&title=scale#9363 Author: Castor63
Subject: 3602
Posted: 11.Apr.2010 at 01:53

Thank you got it]]> Sun, 11 Apr 2010 01:53:54 +0000 https://www.cadforum.cz/forum_en/forum_posts.asp?TID=3602&PID=9363&title=scale#9363 https://www.cadforum.cz/forum_en/forum_posts.asp?TID=3602&PID=9362&title=scale#9362 Author: CarlB
Subject: 3602
Posted: 11.Apr.2010 at 01:43

That scale can also be expressed as 1"= 8 feet or 1"=96 inches.
It would help if you had a 1/8" scale to take measurements off the drawing.
You can choose to use inches or feet units when you draw in AutoCAD.
]]> Sun, 11 Apr 2010 01:43:39 +0000 https://www.cadforum.cz/forum_en/forum_posts.asp?TID=3602&PID=9362&title=scale#9362 https://www.cadforum.cz/forum_en/forum_posts.asp?TID=3602&PID=9361&title=scale#9361 Author: Castor63
Subject: 3602
Posted: 11.Apr.2010 at 00:20

I have taken a measurement off an HVAC diagram, the diagram says 12" and the measured distance is 1/8 of an inch. I realize that meens 0.125"=1' but as all the measurements are different in the diagram I am having a hard time figuring out the easiest way to put this into autocad. I think I'm just having a brain fart ]]> Sun, 11 Apr 2010 00:20:40 +0000 https://www.cadforum.cz/forum_en/forum_posts.asp?TID=3602&PID=9361&title=scale#9361