https://www.cadforum.cz/forum_en/ Thu, 13 Aug 2026 16:49:39 +0000 Thu, 30 Sep 2010 00:48:17 +0000 http://blogs.law.harvard.edu/tech/rss Web Wiz Forums 12.04 360 https://www.cadforum.cz/forum_en/RSS_post_feed.asp?TID=4426 https://www.cadforum.cz/forum_en/forum_images/web_wiz_forums.png https://www.cadforum.cz/forum_en/ https://www.cadforum.cz/forum_en/forum_posts.asp?TID=4426&PID=11304&title=inventor-2011-iauthor#11304 Author: JohnK_TEDCF
Subject: 4426
Posted: 30.Sep.2010 at 00:48

I'm not sure what your actual intent is, pertaining to your project, but if you go into the Help Topics section in Inventor and type in "iCopy", there is quite a bit of information that explains all about iCopy and iAuthor.]]> Thu, 30 Sep 2010 00:48:17 +0000 https://www.cadforum.cz/forum_en/forum_posts.asp?TID=4426&PID=11304&title=inventor-2011-iauthor#11304 https://www.cadforum.cz/forum_en/forum_posts.asp?TID=4426&PID=11152&title=inventor-2011-iauthor#11152 Author: Metalgurrrl
Subject: 4426
Posted: 23.Sep.2010 at 13:06

I recently installed Inventor 2011...trying to figure out some of the new tools etc. Whilst attempting to use iCopy, I found i needed to link the assembly to a .idw file with iAuthor (?) and I've been unable so far to find any info on the web to explain how to do it!


Any help would be appreciated!
]]> Thu, 23 Sep 2010 13:06:55 +0000 https://www.cadforum.cz/forum_en/forum_posts.asp?TID=4426&PID=11152&title=inventor-2011-iauthor#11152