CAD Forum discussion (EN) : Fillet issues when zooming

Fillet issues when zooming : Zoom does not change the elevation...

Mon, 24 Jan 2011 19:14:05 +0000

Author: HAWDesigner
Subject: 5174
Posted: 24.Jan.2011 at 19:14

Zoom does not change the elevation of any object.

When you draw, there are only a couple ways that I know of to place an object on an elevation other than 0.

1. By manually entering the coordinates (X,Y,Z)

Command: L
LINE Specify first point: 0,0,0
Specify next point or [Undo]: @5,5,5
Specify next point or [Undo]:

2. By picking the grip of an object that is already on an elevation other than 0.

If you go into the properties ([CMD]CHPROP[/CMD]) of the objects you want to fillet, you can edit their Z-Axis elevations from there.

You can also [CMD]LIST[/CMD] the items to see what their Z-Axis elevation is.

Edited by HAWDesigner - 24.Jan.2011 at 19:14

Fillet issues when zooming : Yes I get the latter message. Does...

Mon, 24 Jan 2011 17:43:28 +0000

Author: ronoc88
Subject: 5174
Posted: 24.Jan.2011 at 17:43

Yes I get the latter message.

Does that mean as I zoom im am changing the level on the Z axis?

I only draw in 2D. So how do I stop the Z axis from changing and set all existing lines to the same Z.

Fillet issues when zooming : 13 Views is nothing, but the elaboration...

Mon, 24 Jan 2011 16:37:57 +0000

Author: HAWDesigner
Subject: 5174
Posted: 24.Jan.2011 at 16:37

13 Views is nothing, but the elaboration helped, thank you.

When you try to fillet the two lines, what message are you getting?

It would be something like "The Radius is too large.", or "Lines are non coplanar."

The latter message is what you would get if the lines were on two different Z elevations.

Try [CMD]LIST[/CMD]ing both lines to verify they are both at the same elevation.

Fillet issues when zooming : 13 Views no respones? I thought...

Mon, 24 Jan 2011 15:25:37 +0000

Author: ronoc88
Subject: 5174
Posted: 24.Jan.2011 at 15:25

13 Views no respones?

I thought I would elaborate a bit.

If I draw the first line then the second i can fillet them.

If however I draw the first line then change the zoom and draw the second line the wont fillet.

Is it possible that there is a setting that is causing the lines to be drawn at different levels on the Z axis?

If so is this affected by zoom?

Any help much appreciated.

Thanks

Conor

Fillet issues when zooming : Hello there, typical first post...

Mon, 24 Jan 2011 11:26:30 +0000

Author: ronoc88
Subject: 5174
Posted: 24.Jan.2011 at 11:26

Hello there, typical first post im sorry but im stuck.

Fillet works fine then if I zoom out or in it wont fillet.

Any ideas?

Thanks

Edit: Working in AutoCAD 2010

Edited by ronoc88 - 24.Jan.2011 at 11:27