https://www.cadforum.cz/forum_en/ Sat, 16 May 2026 14:23:00 +0000 Tue, 17 May 2011 15:12:04 +0000 http://blogs.law.harvard.edu/tech/rss Web Wiz Forums 12.04 360 https://www.cadforum.cz/forum_en/RSS_post_feed.asp?TID=5901 https://www.cadforum.cz/forum_en/forum_images/web_wiz_forums.png https://www.cadforum.cz/forum_en/ https://www.cadforum.cz/forum_en/forum_posts.asp?TID=5901&PID=15353&title=creating-patio#15353 Author: John Connor
Subject: 5901
Posted: 17.May.2011 at 15:12

Looks like someone posted an answer to your question over at CADTutor.]]> Tue, 17 May 2011 15:12:04 +0000 https://www.cadforum.cz/forum_en/forum_posts.asp?TID=5901&PID=15353&title=creating-patio#15353 https://www.cadforum.cz/forum_en/forum_posts.asp?TID=5901&PID=15337&title=creating-patio#15337 Author: John Connor
Subject: 5901
Posted: 17.May.2011 at 11:45

It appears that all of your walls are surfaces and not solids.  I suspect that you extruded a series of lines.  Is that correct?

Did you know that a solid can be created using the Press/Pull command?


Edited by John Connor - 17.May.2011 at 12:39]]> Tue, 17 May 2011 11:45:42 +0000 https://www.cadforum.cz/forum_en/forum_posts.asp?TID=5901&PID=15337&title=creating-patio#15337 https://www.cadforum.cz/forum_en/forum_posts.asp?TID=5901&PID=15331&title=creating-patio#15331 Author: thrice910
Subject: 5901
Posted: 17.May.2011 at 05:51

Hello all,

I cannot figure out how to create a solid surface on top of  the retaining walls and also how to grade the transitions for the high to low points of the retaining wall. This would be so much easier for me in Solid Works ><  Any help would be appreciated.



Doug
]]> Tue, 17 May 2011 05:51:10 +0000 https://www.cadforum.cz/forum_en/forum_posts.asp?TID=5901&PID=15331&title=creating-patio#15331