https://www.cadforum.cz/forum_en/ Thu, 03 Sep 2026 03:15:26 +0000 Sat, 25 Jun 2011 05:22:29 +0000 http://blogs.law.harvard.edu/tech/rss Web Wiz Forums 12.04 360 https://www.cadforum.cz/forum_en/RSS_post_feed.asp?TID=6031 https://www.cadforum.cz/forum_en/forum_images/web_wiz_forums.png https://www.cadforum.cz/forum_en/ https://www.cadforum.cz/forum_en/forum_posts.asp?TID=6031&PID=15936&title=command-chamfer#15936 Author: Joferna
Subject: 6031
Posted: 25.Jun.2011 at 05:22

I  want to share this info about chamfer  with you.  If you have two solids  say a  circular  shaft  attached to a  circular plate  and if you  try to chamfer the  joint between the two solids , to make it look like a weld the chamfer will narrow  the  joint. However if you Union the two soilds  and then chamfer, you will get a a nice  weld like  chamfer at the joint. ]]> Sat, 25 Jun 2011 05:22:29 +0000 https://www.cadforum.cz/forum_en/forum_posts.asp?TID=6031&PID=15936&title=command-chamfer#15936 https://www.cadforum.cz/forum_en/forum_posts.asp?TID=6031&PID=15631&title=command-chamfer#15631 Author: John Connor
Subject: 6031
Posted: 07.Jun.2011 at 18:09

There isn't any.  Use Chamfer with a "0" setting instead.]]> Tue, 07 Jun 2011 18:09:52 +0000 https://www.cadforum.cz/forum_en/forum_posts.asp?TID=6031&PID=15631&title=command-chamfer#15631 https://www.cadforum.cz/forum_en/forum_posts.asp?TID=6031&PID=15624&title=command-chamfer#15624 Author: m2double
Subject: 6031
Posted: 07.Jun.2011 at 12:28

Hello,

What is the reverse comand for Chamfer (working with 3D solids)?
]]> Tue, 07 Jun 2011 12:28:36 +0000 https://www.cadforum.cz/forum_en/forum_posts.asp?TID=6031&PID=15624&title=command-chamfer#15624