1.   Which of the followingAutoCAD features allows you to pick up points only along the horizontal andvertical quadrant lines from a given starting point?

 A. LINE

B. Snap

C. Ortho

D. 3D Object Snap

My Answer: B   

 3.   Which of the followingstatements about Grid is correct?

 A. Grid is only a visual reference; it has no effect on the selectionof points.

B. Grid effects the selection of points.

C. Grid is invisible.

D. Grid and Snap always have the same setting.

My Answer: B   

 8.   When you're inputtingcoordinates at the on-screen prompt, which one of the following statements iscorrect?

 A. Relative coordinates are specified by typing coordinates with noprefix.

B. Absolute coordinates are specified by typing the @ prefix.

C. Relative coordinates are specified by typing the # prefix.

D. Absolute coordinates are specified by typing the # prefix.

My Answer: A   

 10.   When drawing a horizontalline that's 15 decimal units long to the right, the correct polar coordinatedisplay should read

 A. 15.0000 < 90,0.0000.

B. 0.0000 < 15,0.0000.

C. 15.0000 < 180,0.0000.

D. 15.0000 < 0,0.0000.

My Answer: C   

 13.   The default paper size andgrid line increments for an acad.dwt drawing template is

 A. 8 1/2 inches × 11 inches, and 1.0000 spacing.

B. 12 inches × 9 inches, and 0.5000 spacing.

C. 11 inches × 17 inches, and 1.0000 spacing.

D. 24 inches × 36 inches, and 0.5000 spacing.

My Answer: C   

 14.   After executing the ZOOMcommand, the following information appears in the command line:

 [All/Center/Dynamic/Extents/Previous/Scale/Window/Object]

If you press <Enter> on your keyboard in response to this prompt,which of the following ZOOM options will be activated?

C. All

D. Extents

My Answer: C   

 16.   Where should you look onthe AutoCAD screen to find the application status bar?

 A. On the left edge of screen

B. At the top of the screen

C. At the bottom of the screen

D. On the right edge of the screen

My Answer: D   

 17.   Using Dynamic Input anddecimal units, imagine that you've drawn a jagged line that ends at theabsolute coordinates (5, 8). To draw a line back to the XY origin usingabsolute coordinates, you should type _______ at the Specify next point:prompt.

A. −5, −8

B. 0,0

C. #−5,−8

D. #0,0

My Answer: A   

 20.   You can press the<F7> key in AutoCAD to turn on the

 A. Polar Tracking.

B. Ortho Mode.

C. Grid Display.

D. Snap Mode.

My Answer: B