CAD Forum - Database of tips, tricks and utilities for AutoCAD, Inventor and other Autodesk products [www.cadforum.cz]
Czech English Deutsch
Login/Register:
 Visitors: 6500 
RSS tips RSS channel - CAD tips
RSS discussion RSS channel - CAD discussion

Discussion Discussion forum

HelpCAD discussion

CAD Forum - Homepage CAD discussion forum - ask any CAD-related questions here, share your CAD knowledge on AutoCAD, Inventor, Revit and other Autodesk software with your peers from all over the world. To start a new topic, choose an appropriate forum.

Please abide by the rules of this forum.

How to post questions: register or login, go to the specific forum and click the NEW TOPIC button.
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

The information that you provide in this form will make up your forum profile which can be viewed by other forum members. Your email address will only be visible by forum admin and moderators and will be used to send you Forum Notifications. To cancel your account, use the page Opt-out or contact webmaster@cadforum.cz.

3D printing

 Post Reply Post Reply
Author
Glynndale702 View Drop Down
Newbie
Newbie


Joined: 29.Apr.2018
Location: United States
Using: 2007
Status: Offline
Points: 2
Post Options Post Options   Thanks (0) Thanks(0)   Quote Glynndale702 Quote  Post ReplyReply Direct Link To This Post Topic: 3D printing
    Posted: 01.May.2018 at 07:29

I am trying to create a project for 3 D printing this is my first time and I having allot trouble doing it can any body help me figure this out I would really appreciate it what I am trying to do is make a new car radio dash bezel the measurements for it is in picture attached picture 1 I tried to created  a stl file so it could be printed so I don’t know if I did this right can anybody take a look at this and tell what’s wrong or help me design it better I went to send it to get printed but then it asked me scale it is this the right measurements to get it printed

 

 

Size 1.00 x20.00x13.64mm (0.04 x 0.79 x 0.54 in)

 

 

I would appreciate any help thanks guys

Back to Top
John Connor View Drop Down
Senior Member
Senior Member


Joined: 01.Feb.2011
Location: United States
Using: AutoCAD 2018
Status: Offline
Points: 6902
Post Options Post Options   Thanks (0) Thanks(0)   Quote John Connor Quote  Post ReplyReply Direct Link To This Post Posted: 01.May.2018 at 11:18
A quarter of an inch thick?  Seems rather thick for a bezel.

You don't give the radius for the two upper corners nor do you provide a radius for the filleted edge.

So you created a drawing in AutoCAD and exported it as a .stl file.  Is that correct?
"Humans have a strength that cannot be measured. This is John Connor. If you are reading this, you are the resistance."

<<AutoCAD 2015>>

Back to Top

Related CAD tips:


 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down



This page was generated in 0,059 seconds.