Splines are uneditable!
Printed From: CAD Forum
Category: EN
Forum Name: AutoCAD
Forum Description: Discussion about AutoCAD and AutoCAD LT, viewers, DWG and DWF formats, Design Review, AutoCAD 360, add-ons
URL: https://www.cadforum.cz/forum_en/forum_posts.asp?TID=10028
Printed Date: 31.May.2026 at 21:22
Topic: Splines are uneditable!
Posted By: Tasharon
Subject: Splines are uneditable!
Date Posted: 06.Feb.2014 at 19:52
|
Something has happened to my splines... I drew a long curved line with the spline command, and when I revisit the line later and select it, the square handles have turned to circles, and there are LOADS of the, making them near impossible to edit as there are so many handles to move, and then the line ends up all wobbly as I've not managed to line them all up right. Also, AutoCAD doesn't seem to be recognising them with other commands. If I try and trim one such sline against another, it won't work half the time. Also sometimes they won't offset - or even weirer, only a part of them will offset, or they might offset in part, but only on one side. No idea how this is happening - I'm a relative newbie to AutoCAD as I'm a student so hopefully it's nothing too complicated! Thank you in advance! :)
|
Replies:
Posted By: John Connor
Date Posted: 06.Feb.2014 at 23:38
|
What are you drawing that you are using splines? ------------- "Humans have a strength that cannot be measured. This is John Connor. If you are reading this, you are the resistance." <<AutoCAD 2015>> |
Posted By: philippe JOSEPH
Date Posted: 07.Feb.2014 at 06:57
|
Hello Tasharon, would it save you to PEDIT your "spline" and transform it into a polyline ?
Trimming or extending polylines and splines is not allways good.
Other ways : there are ending grips on your spline, select your spline and move slowly your mouse on one ending point,
see what message appears with 4 editing options for you to "work" your spline.
Tell us what happens.
With the old releases of AutoCAD I use to definte the ending tangencies on the command line but with my 2013 I have to come back on the spline ending grips to set it OK.
 |