xref
Printed From: CAD Forum
Category: EN
Forum Name: CAD - general
Forum Description: General discussion about CAD, formats, standards, management, licensing, networking, harware, other CAD applications
URL: https://www.cadforum.cz/forum_en/forum_posts.asp?TID=10031
Printed Date: 25.May.2026 at 10:56
Topic: xref
Posted By: pytha
Subject: xref
Date Posted: 07.Feb.2014 at 19:46
Can you at xref automatically his new path.
-------------
bart
|
Replies:
Posted By: John Connor
Date Posted: 07.Feb.2014 at 22:20
There are three path options for a xref. They are...
No path
Full path
Relative path
Which one do you normally use?
Are you looking for a lisp routine to automate the process?
You question just doesn't seem to make much sense.
-------------
"Humans have a strength that cannot be measured. This is John Connor. If you are reading this, you are the resistance."
<<AutoCAD 2015>>
|
Posted By: John Connor
Date Posted: 07.Feb.2014 at 22:28
Here is a link to a thread that contains a lisp routine written by BlackBox to set the path of an Xref. Maybe that's what you are looking for?
http://forums.augi.com/showthread.php?123746-Lisp-to-set-Xref-path
-------------
"Humans have a strength that cannot be measured. This is John Connor. If you are reading this, you are the resistance."
<<AutoCAD 2015>>
|
Posted By: pytha
Date Posted: 07.Feb.2014 at 23:11
if I move from workstation. xref are not connect.
I need them again each conect. much work can conect it not automaticl.?
-------------
bart
|
Posted By: John Connor
Date Posted: 08.Feb.2014 at 16:31
Are the xrefs stored on a network drive?
It would be nice if you provided ALL the information up front in your first post.
To repath your xrefs, without opening each drawing, use the Reference Manager.
AdRefMan.exe
-------------
"Humans have a strength that cannot be measured. This is John Connor. If you are reading this, you are the resistance."
<<AutoCAD 2015>>
|
|