Layer control
Printed From: CAD Forum
Category: EN
Forum Name: AutoCAD
Forum Description: Discussion about AutoCAD and AutoCAD LT, viewers, DWG and DWF formats, Design Review, AutoCAD 360, add-ons
URL: https://www.cadforum.cz/forum_en/forum_posts.asp?TID=10433
Printed Date: 31.May.2026 at 23:19
Topic: Layer control
Posted By: GreenForest
Subject: Layer control
Date Posted: 02.Jul.2014 at 17:45
|
I am using ACAD 2009 Lte. Suppose I need to use only the information on a single layer. Say I want to copy and paste a single layer from one drawing to another. How can I do this without freezing all but the layer that I want to copy??? thanks H. Hampton.
-------------
HWH
|
Replies:
Posted By: John Connor
Date Posted: 02.Jul.2014 at 17:52
Use the QSELECT command.
-------------
"Humans have a strength that cannot be measured. This is John Connor. If you are reading this, you are the resistance."
<<AutoCAD 2015>>
|
Posted By: anubhav1237
Date Posted: 03.Jul.2014 at 08:49
You can use Filter & Qselect commands. you can also use LAYISO by isolating the layer only.
If you want to copy information on one single layer from one drawing to another, you can use the above commands and just copy them into different drawing. The properties of that layer will only be added in that drawing.
|
|