Print Page | Close Window

Arrayed object will not extrude

Printed From: CAD Forum
Category: EN
Forum Name: AutoCAD
Forum Description: Discussion about AutoCAD and AutoCAD LT, viewers, DWG and DWF formats, Design Review, AutoCAD 360, add-ons
URL: https://www.cadforum.cz/forum_en/forum_posts.asp?TID=10452
Printed Date: 31.May.2026 at 20:13


Topic: Arrayed object will not extrude
Posted By: Blueoctober712
Subject: Arrayed object will not extrude
Date Posted: 10.Jul.2014 at 01:06
Please help!!! I created a gear that I need to extude to 1 inch. After I created the object and did all the trimming it will not join as one object using the join command or become a region. It will join together as a block. But the block will not extrude with the extrude command, thicken command etc. I attached a DWG copy. Thank you so much in advance


uploads/481025/sprocket_problem.dwg" rel="nofollow - uploads/481025/sprocket_problem.dwg


-------------
Regards,
Shan


Replies:
Posted By: Blueoctober712
Date Posted: 10.Jul.2014 at 02:14
ok well I used presspull command to get the extrusion. So it looks like a solid object. However it is not and I need to cut out a smaller circumference from the middle for were the axle will slide through. Thanks again

-------------
Regards,
Shan


Print Page | Close Window