Design of a Ring
Printed From: CAD Forum
Category: EN
Forum Name: AutoCAD
Forum Description: Discussion about AutoCAD and AutoCAD LT, viewers, DWG and DWF formats, Design Review, AutoCAD 360, add-ons
URL: https://www.cadforum.cz/forum_en/forum_posts.asp?TID=10746
Printed Date: 18.Apr.2026 at 22:37
Topic: Design of a Ring
Posted By: jamesfalzon280
Subject: Design of a Ring
Date Posted: 22.Oct.2014 at 18:41
Hi all, I'm designing this annuloplasty ring, image attached below. I'm finding problems how to actually design it thought it seem easy? How would you go about it ? Any help will be greatly appreciated. Thanks  |
Replies:
Posted By: John Connor
Date Posted: 23.Oct.2014 at 00:37
|
I don't use Inventor but in AutoCAD I'd construct the centerline of the ring using splines perhaps then sweep a circle along this path. Then I'd punch holes through the ring where needed. ------------- "Humans have a strength that cannot be measured. This is John Connor. If you are reading this, you are the resistance." <<AutoCAD 2015>> |