mm by Default
Printed From: CAD Forum
Category: EN
Forum Name: Inventor
Forum Description: Discussion about Autodesk Inventor
URL: https://www.cadforum.cz/forum_en/forum_posts.asp?TID=10789
Printed Date: 11.May.2026 at 00:17
Topic: mm by Default
Posted By: maestrtoaku
Subject: mm by Default
Date Posted: 24.Nov.2014 at 14:05
I have a question about configuring mm in inventor, because every time i open a drawing or assembly, those ones open as "inch" and i want to open them as "mm". Probably you guys will say "you need to go to Tools/Documents Settings/Units and change it" and it is OK, but i do need to set it "by default" as mm. because it is pretty odd i change it every time i open a drawing.
Please
p.S: the pieces coming as mm but anywhere they open as inches
|
Replies:
Posted By: John Connor
Date Posted: 24.Nov.2014 at 14:24
This solution regarding your problem was posted over at the Inventor Discussion Group.
You have to replace the Standard.i?? templates in your default templates folder with the ones from the Metric templates folder.
-------------
"Humans have a strength that cannot be measured. This is John Connor. If you are reading this, you are the resistance."
<<AutoCAD 2015>>
|
Posted By: maestrtoaku
Date Posted: 24.Nov.2014 at 14:50
|