Constraints
Printed From: CAD Forum
Category: EN
Forum Name: AutoCAD
Forum Description: Discussion about AutoCAD and AutoCAD LT, viewers, DWG and DWF formats, Design Review, AutoCAD 360, add-ons
URL: https://www.cadforum.cz/forum_en/forum_posts.asp?TID=10847
Printed Date: 01.Jun.2026 at 00:58
Topic: Constraints
Posted By: miscille
Subject: Constraints
Date Posted: 10.Dec.2014 at 16:56
Hi
I have been working on AutoCAD for many years.
I am currently running AutoCAD 2013
I am working using another firms x-ref's. When I brought in their x-ref, it triggered 'Constraints', I have stayed away from using them as they are hard to get rid of....sure enough, I cannot get rid of them. I find them very hard to work with, of course my deadline is very tight. I have found that they are now present in all my drawings, even drawings generated here. I suspect it is a setting gone awry. I can find temporary relief using delconstraint, but that only lasts a minute. I want to get rid of them altogether until I have time to figure out how to work with them properly.
CAn anyone shed any light on this?
Thanks and Merry Christmas
|
Replies:
Posted By: John Connor
Date Posted: 10.Dec.2014 at 19:44
Look on your Status Bar. The icon furthest to the left should be the one labeled "Infer Constraints". Toggle it OFF.
-------------
"Humans have a strength that cannot be measured. This is John Connor. If you are reading this, you are the resistance."
<<AutoCAD 2015>>
|
|