Print Page | Close Window

2015 Jumps out of viewport

Printed From: CAD Forum
Category: EN
Forum Name: AutoCAD
Forum Description: Discussion about AutoCAD and AutoCAD LT, viewers, DWG and DWF formats, Design Review, AutoCAD 360, add-ons
URL: https://www.cadforum.cz/forum_en/forum_posts.asp?TID=10875
Printed Date: 31.May.2026 at 18:15


Topic: 2015 Jumps out of viewport
Posted By: mmelchert
Subject: 2015 Jumps out of viewport
Date Posted: 20.Dec.2014 at 14:06
All,
I am new to this forum but am seasoned with CAD (AutoCAD in particular).

I have recently upgraded my department to 2015 and have noticed a few odd occurrences.  One nuisance takes place while using a command within model space in a viewport.  After the command is complete, CAD jumps back into paper space. This is an inconsistent occurrence but is annoying nonetheless since a lot of my guys do many revisions direct from the layouts.  

Has anyone else had this issue?  I do not know of any setting that would control this.
Thx 


Replies:
Posted By: John Connor
Date Posted: 20.Dec.2014 at 22:35
Can't say I have encountered this particular anomaly although I have been using 2015 since late April.

So this behavior can occur while using any command on any drawing that involves working through a paper space viewport?

I don't know of any setting that would influence this behavior good or bad.

Did you also install the service pack as well?


-------------
"Humans have a strength that cannot be measured. This is John Connor. If you are reading this, you are the resistance."

<<AutoCAD 2015>>


Print Page | Close Window