Block Attribute Move with Lookup
Printed From: CAD Forum
Category: EN
Forum Name: AutoCAD
Forum Description: Discussion about AutoCAD and AutoCAD LT, viewers, DWG and DXF formats, Design Review, AutoCAD web, Drive, add-ons
URL: https://www.cadforum.cz/forum_en/forum_posts.asp?TID=11567
Printed Date: 05.Sep.2026 at 22:34
Topic: Block Attribute Move with Lookup
Posted By: Hobblenobble
Subject: Block Attribute Move with Lookup
Date Posted: 07.Jan.2016 at 14:21
|
Apolgies as a newbie if not posted in the correct discussion. I am pulling out what hair I have left !!!!! I want to generate a dynamic block with an attribute. The attribute in the block depending on the visiblity state (Up/down), should be above or below a line. The distance the attribute needs to move is 8mm. i have tried and dont think I am far off the answer  I can create the block and atrribute. I have inserted a linear parameter. A look up table based on the two visible states. It is the move aspect that i think i am stuck on. Any help would be more than appreciated. Kind regards, ------------- Hobblenobble |