Print Page | Close Window

Sweep command problem

Printed From: CAD Forum
Category: EN
Forum Name: AutoCAD
Forum Description: Discussion about AutoCAD and AutoCAD LT, viewers, DWG and DXF formats, Design Review, AutoCAD web, Drive, add-ons
URL: https://www.cadforum.cz/forum_en/forum_posts.asp?TID=11587
Printed Date: 17.Jul.2026 at 16:48


Topic: Sweep command problem
Posted By: 4riders
Subject: Sweep command problem
Date Posted: 18.Jan.2016 at 08:09
Hello, 
i try to  do sweep command. i have used with no problems until now.
When i used sweep command it was sweeping this shape into a solid.
Now, when i sweep it converts it into a surface.
Do you have a solution to sweep this shape into a solid and not in a surface ?
uploads/526420/dormitor_lupu.dwg" rel="nofollow - uploads/526420/dormitor_lupu.dwg


Replies:
Posted By: 4riders
Date Posted: 18.Jan.2016 at 08:58
i tryed sweep command with surface mode 1 - 0 but it creates surface or nurbs surfaces.
i tryed extrude command with solid mode on but it says :
path curve is coplanar with or tangent to the plane of the profile curve

Posted By: John Connor
Date Posted: 18.Jan.2016 at 12:27
You must be doing something wrong then.  The key line in the error message is the last one that starts "curve path is coplanar...."  You'll have to try again.


-------------
"Humans have a strength that cannot be measured. This is John Connor. If you are reading this, you are the resistance."

<<AutoCAD 2015>>

Posted By: philippe JOSEPH
Date Posted: 18.Jan.2016 at 12:58
Hello 4riders and John, I have open your file and found :
5 Solids OK , 6 closed polylines OK for the command : EXTRUDE and 2 non coplanar lines.
Please let us know on which entity you have a problem.


Print Page | Close Window